High-country-tek HGC-2, Closed Loop Controller Manual do Utilizador descarregar pdf (Página 21)

Hydraulic Generator Controller – HGC-2

HGC-2 Error code Description (STATUS):

IMPORTANT NOTES:-

• ALWAYS Mount HGC-2 controller with I/O connector facing downwards to avoid debris collection.

• Recommended tightening torques for securing bolts on the HGC-2 module are as follows:-

For 2 x #6 (4mm) bolts - Dry Torque = 6 Ft-Lbs - Lubricated Torque = 4 Ft-Lbs

Label Inches Millimeters

A 3.0 76.2

B 2.0 50.8

C 0.25 6.4

D 1.0 25.4

E 0.188 4.80

HGC-2 Hardware Description:

Blink Definition

OFF

System is OK and operating normally

2 Open Circuit On Controller Output – wires to solenoid disconnected while under power

3 Short Circuit On Controller Output - wires or solenoid have become short circuited

5 Frequency Fault – output frequency has been below min. or above max. for greater than fault time

Note:-

• The ‘STATUS’ led is a monitor is used to indicate locally the controller operation only

• NO external output is provided to mimic the STATUS led

1 2 ... 16 17 18 19 20 21 22 23 24

Sem comentários

High-country-tek HGC-2, Closed Loop Controller Manual do Utilizador Página 21