High-country-tek HFS-2Q Manual do Utilizador descarregar pdf (Página 18)

Hydraulic Fan System Controller : HFS - 2

Retry ALL Faults:

The user setting “retry all faults” determines if the unit will retry faults that are detected with the controller or

peripheral devices after 4 seconds or if NOT selected, the unit will stop operation until the power supply is turned OFF

and back ON.

If after a power reset, the fault is cleared, the unit will return to normal operation. If the fault persists, the controller will

once again stop and repeat the procedure above.

PC H d R i t

•Windows

NT, 2000 , XP and Vista operating system.

• 2mB free hard disk.

• 68mB memory( min )

• Unallocated DB9 serial communication port OR

U ll t d USB t ith li d USB t DB 9 h b d d ith USB d i ft i t ll d tl

PC H

ware

equ

remen

This is the method by which the fan controller is set-up and monitored and is explained more fully on page 26 of this

manual.

The initial Opto 2000 unit must be ordered separately to the main controller but this is a universal communications

adapter which will be used with other upcoming HCT controllers and products

•

oca

d USB

por

ith

user

supp

d USB t

DB 9 h

powere

ith USB d

ver

ware

correc

Opto 2000 Communications:

adapter which will be used with other upcoming HCT controllers and products

Set-Up Software:

High Country Tek Inc. has realized that digital electronics comes with the

need for the user to communicate with the controller and with this

comes a new set of practical problems associated with having to learn

and

become

proficient

with

the

set

software

and

hardware

and

become

proficient

with

the

set

software

and

hardware

connections.

The software for this product is available from HCT and loads itself into a

subdirectory ( the user is urged to allow the default directory paths ).

This new generation of controller setup programs is specifically designed

to be easy-to-use with a non threatening approach and with only the

necessar

items displayed ( determined b

password levels )

ogivea

non-cluttered display that is clear and understandable to both the

professional and casual user.

The controller-to-PC communications is taken care of by the Opto 2000

unit which is plug and play in that all the user needs to do is physically

connect the unit and run the provided software for the full automatic

setup.

The Opto 2000 should be connected to the host PC first and the HFS software started. The PC will immediately check the

available ports, display a list ( shown right ) of available serial ports, find the Opto 2000 and connect. If the Opto 2000 is

connected to an HFS that has power applied, the program will take a few seconds to check module validity and then display the

settings from that module. At this point, the user may enter a password if changes to settings are required.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Comentários a estes Manuais

Sem comentários

High-country-tek HFS-2Q Manual do Utilizador Página 18

Comentários a estes Manuais

Manuais e produtos relacionados com Sensores High-country-tek HFS-2Q